Old Part Numbers: 2-200-340
Fits saltwater Minn Kota trolling motor models with 112 pounds of thrust from 2014 - 2018 and most models from 2019, excluding Minn Kota RT/ST, Riptide Saltwater Terrova, Riptide Terrova and Riptide Ulterra models.
This center housing will measure 8-1/8" in length and 4-1/2" in outside diameter
Anytime a lower unit is reassembled, the thru bolts need to be tightened within 40 - 50 inch pounds for 4-1/2" diameter lower units.
In June of 2019, the 112 pound lower units went through a design change. Minn Kota removed the timing key on the Center Housing and the mating Brush End Housing. (The key was there to help prevent the skag from being rotated and affecting the motor timing.) The new design better positions the O-ring against the shoulder of the Brush End Housing. If your motor is from 2019, you will need to check for the presence of the key slot in your brush end housing.
If your brush end housing has this key slot, this is the correct p/n for your motor. If your motor does not have this key slot, you will need p/n 92-200-350.
To rectify this change, you will receive the following parts when ordering this part number:
|Quantity||Part Number||Part Description|
|1||92-200-350||Center Housing Assembly SW|
|1||92-300-176||Brush End Housing Assembly SW|
|2||880-025||Prop Shaft Seal|
|1||144-017||Flange Bearing LRG|
||O Ring 4-1/2" LU
|2||701-009||Thru Bolt O Ring|
Not sure if this part will fit your Minn Kota trolling motor? Parts Diagrams