Northland Marine

Minn Kota 24/36v Control Board Assembly 2774066

Part Number:  2774066V

Old Part Numbers:  2324061, 2774066

Minn Kota Terrova BT and Riptide Terrova BT 24/36 Volt Control Board Assembly (2 Port)

Fits the following Minn Kota trolling motor models:

  • Minn Kota Riptide Terrova BT 80 models from 2017 - Present
  • Minn Kota Riptide Terrova BT 112 models from 2017 - Present
  • Minn Kota Terrova BT 80 models from 2017 - Present
  • Minn Kota Terrova BT 112 models from 2017 - Present

If your Minn Kota Terrova or Minn Kota Riptide Terrova comes factory equipped with iPilot or iPilot Link only one of the accessory plugs will be used.

Installation Instructions

Parts included with this assembly:

 Quantity Part Number Part Description
1 2324061 24/36v Control Board Assembly
4 2305401 Shrink Tube - .374 ID x 1.5"
3 2305410 Shrink Tube - .315 OD x 2.25"
1 2305415 Shrink Tube - .472 ID x 2.25"
1 2325401 Shrink Tube - .750 ID x 2"

If you have lost steering function, please read:

Terrova/ST motors use drive housings that are specific to the voltage of the motor.  For example, a Terrova 55/ST 55 uses a 12-volt drive housing, a Terrova 80/ST 80 uses a 24-volt drive housing, and a Terrova 101 & Terrova 112/ST 101 & ST 112 use a 36-volt drive housing. To properly test the drive housing apply the voltage appropriate for the model directly to the drive housing leads while observing the drive housing amp draw. The amp draw under bench test, no load, conditions should be less than 2 amps for a 12-volt drive housing, and less than 1.5 amps for 24-volt and 36-volt drive housings. (NOTE: Reverse the polarity at the drive housing leads to check amp draw in both clockwise and counterclockwise rotation.) If the drive housing amp draw exceeds the values listed (2 amps for 12-volt drive housings or 1.5 amps for 24-or 36-volt drive housings) suspect that the drive housing has taken out the steering circuit on the main control board.  (NOTE: When this has occurred the drive housing MUST be repaired or replaced prior to replacing the main board. If the higher than normal amp draw of the drive housing is not corrected the steering circuit on the new/replacement main control board will also fail.)

Not sure if this part will fit your Minn Kota trolling motor?  Parts Diagrams

Frequently Bought Together