Old Part Number(s): 2304046, 2304055, 2304060, 2304064, 2304084, 2884046
Fits the following Minn Kota trolling motor models:
Thrust levels include 40, 42, 45, 50, 54 and 55
Serial Numbers will contain the following designations after the WW:
or will start with the following letters:
J, K, L, M, N, O, P, Q, R, S, T, U, V, 22, 23
This control board is NOT compatible with these models equipped with AutoPilot. If your 12 volt models has AutoPilot you will need p/n 2884057
Not sure if this part will fit your Minn Kota trolling motor? Parts Diagrams.
Got my order promptly part installed my trolling motor is working fine. Thanks.
The instructions were good. No problem installing it. I finally got out on the water today and still have problems. I got it pared ok. The 0 through 10 speeds work fine but my steering motors don't seem to work. I'll check to see if the are getting voltage from the controller or if they are shot. Sorry for the late review. There is a lot going on this summer. The man I talked to at Northland Marine was very helpful.
Very good customer service. Would highly recommend these guys and good prices.
Recently I contacted Northland Marine and discussed a problem I was having with my Power Drive V2 trolling motor. The fellow I spoke with and I concurred that the problem was in the main control board. What I forgot to mention was that I just finished installing a new co-pilot. When I tested the co-pilot, there was no responce. I then tried the foot control and it would not work either. I removed the co-pilot and removed the cover plate off of the co-pilot circuit board and found that 3 of the wires had been pinched during the manufactoring process. The insulation was squeezed off leaving exposed wires that shorted out the co-pilot board and the new main control board that I purchaced from Northland Marine. I took my trolling motor back to the MinnKota repair depot in Winnipeg, showed them the co-pilot wiring problem and told them that the co-pilot shorted out my new control board from Northland. The repair depot installled a new control board and repaired the co-pilot at no charge. Very satisfied with the people at Northland and the MinnKota repair depot in Winnipeg 👍
And all the parts where correct
The first control board was defective, however the company once the board was tested after I returned it, they were quick to send me a new one that worked as it was supposed to. Would have given them 5 stars if I didn’t have to pay for return shipping on the defective unit.
You are representative, andrew, was extremely knowledgeable and zero did on my problem with the first phone visit.
Easy as 123, i called the shop before ordering and the tech who answered me was top notch, he knew his stuff real well. I will order and retrofit some more, next ipilot retrofitting! Thanks
The product arrived ahead of schedule and was a perfect fit.